FN Herstal Firearms banner

1 - 5 of 5 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter · #1 ·
Here's some shots of my PS90 with an ATN ultra compact mounted to it.

I milled the ATN rail mount down to .095, flattened the bottom, drilled a hold and counter sink for the old sight screw, then file fit it to the slot the rear mount of the factory sight. The barrel center to center of lense is 4.25 inches. Don't know how I feel about it yet, but one nice thing is room for a laser down where the old sight was.








 

·
Registered
Joined
·
15,559 Posts
Nice work. A few guys here have done some milling and other stuff. If you have the skills and equipment, that's pretty cool.

I wish I could do that.
 

·
Premium Member
Joined
·
3,590 Posts
Tooo bad you can't move it to the front of the receiver because then it would be as low if not lower than the stock sight.
 
1 - 5 of 5 Posts
Top