FN Herstal Firearms banner
1 - 1 of 1 Posts

· Registered
Joined
·
480 Posts
You are unable to set the hammer back (SA) by either cocking the slide or pulling the hammer back with your thumb; the pistol will only work in DA mode. The problems began when operating the pistol at home when dry firing but the pistol works fine with ammunition (range); Dry firing the FNX will not cause any problems. If you cannot pull the hammer back or if you pull the trigger and the hammer does not move or the hammer does not strike the firing pin there is a problem with the FCG and the pistol will need to be serviced by FNH USA.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top