FN Herstal Firearms banner

1 - 5 of 5 Posts

·
Registered
Joined
·
362 Posts
Discussion Starter · #1 ·
I have a question for those that own / have handled a SCAR. I was planning on mounting an Eotech on my SCAR (whenever I can get it that is) and the following kind of concerns me.

The Eotech is wide enough that there seems to be quite a bit of overhang on both sides of the rifle. With the bolt handle so high on the rifle, will I be busting my knuckles on the Eotech when I pull it back?

I have trouble believing that would be the case since SOCOM tested the rifle and were planning on using Eotechs on them, but I would like to make sure. Any thoughts on the matter would be appreciated.
 

·
Registered
Joined
·
1,325 Posts
Bump for this older question.

I too am curious about this. The clearance with my EOTech/SIG 556 is pretty close, now that there are more SCARs, how is the clearance?
 

·
Premium Member
Joined
·
25,418 Posts
Just move the sight out farther towards the gas block. Simple fix. :?

PEACE THROUGH STRENGTH
 

·
Registered
Joined
·
1,325 Posts
SgtStrykerUSMC43 said:
Just move the sight out farther towards the gas block. Simple fix. :?
Thanks, yes, it would be a simple fix except I do not prefer the Eotech that far forward and with a Pvs14 it can't be that far forward. :?
 

·
Premium Member
Joined
·
25,418 Posts
Well, that's the first I read of a NVD saddled up to it. I'll have my "people" look into this. :D

PEACE THROUGH STRENGTH
 
1 - 5 of 5 Posts
Top