[Two-Ton Twenty-One]

Looking for the sizes in mm or inches of the tools needed to disassemble the FNAR to field strip. IE bolt out of the rifle so I can buy a combo tool or 2 online allowing me to have only 1 or 2 tools needed to take down the rifle.

So please provide the size of any Allen or torx needed and size of any screwdriver needed.

 

[ShootingSight]

I'm missing something. A standard pattern AR does not need any tools to field strip, other than a bullet tip.

You press out the rear takedown pin - using the tip of a bullet if necessary, but substituting any semi-pointed object like the tip of a cleaning rod if it is stiff.
You break the rifle, and pull back on the charging handle, and the bolt and bolt carrier slip out.
Then you pull out the cotter pin on the side of the bolt carrier and the bolt is field stripped .....

Sometimes, needle nose pliers help get the cotter pin out.

 

[jhs27275]

I'm missing something.

Yep.

He's asking about a FNAR.

 

[jhs27275]

Looking for the sizes in mm or inches of the tools needed to disassemble the FNAR to field strip. IE bolt out of the rifle so I can buy a combo tool or 2 online allowing me to have only 1 or 2 tools needed to take down the rifle.

So please provide the size of any Allen or torx needed and size of any screwdriver needed.

Did you read the owners manual?

 

[Two-Ton Twenty-One]

Did you read the owners manual?

Of course did, it makes no mention of the tool sizes required, neither does any of the online videos I have watched for disassemble. I need the sizes so I can order combination tools and have them be the right size. The manual was junk btw probably one of the least detailed manuals ever.