FN Herstal Firearms banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I bought this FNX 9 used but in great condition, didn't look like too many rounds through it. I have put probably 3k rounds through it. I have had this issue rarely but when it happens I have to pull the safety out and angle the whole hammer assembly to get the trigger bar back underneath to where it is supposed to be. It is starting to happen more often. The trigger bar somehow gets in front of where it should be. This happened while shooting the other day and I am wondering what can be done to fix it, it is annoying to have to happen but this is also a defense gun so could be deadly. I am posting a picture of what it looks like when it happens, I know the gun is dirty but every single spec of dust shows up with the flash. So when this happens it tries to over extend the hammer and the hammer won't fall, it stops about halfway and then when you pull the trigger it tries to recock it but can't because it over extends. Any help with this issue would be appreciated.
 

Attachments

·
Premium Member
Joined
·
21,737 Posts
Have you called FN repair 1-800-635-1321 ?
 

·
Registered
Joined
·
21,553 Posts
I would give FN a call. There's something going on that they should fix.
 
1 - 4 of 4 Posts
Top