FN Herstal Firearms banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,733 Posts
Discussion Starter #1
Hi guys. I detail stripped my FNX slide today and the retaining plate was a PITA to remove. It seemed to be held by some force. Once I removed it and after watching Buffmans videos I became confused on the correct orientation
A. 20140419_140921.jpg this is the way it was from the factory with the dimples facing up. Takes force to install/remove
B. 20140419_140940.jpg this is the way that the video explains to install it. Takes very little force if any to install/remove.
I believe that the correct way would be the way it was from the factory (A) but any input would be greatly appreciated. Thanks
 

·
Registered
Joined
·
21,554 Posts
The way from the factory is correct. You'll notice the bottom portion is more rounded the way it came from the factory and is how it should be reinstalled.
 
1 - 2 of 2 Posts
Top