FN Herstal Firearms banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2,118 Posts
Discussion Starter #1
Trying to figure out where the threaded female receiving thingies go... on the inside of the belt? They have sharp little tongs on them so I'm worried about chewing up the belt. But maybe that's the point... they dig in so they don't move around?


Anyone else using this system? It's been kind of frustrating so far. The directions are worthless. There are screws with serrations along the back, screws without serrations along the back, receiving screws... and nebulous generalized pictures and worthless instructions. :p


I understand that the forks/clips mount onto the accessories/holsters/whatever, and the flat square plates mount to the belt. It's what screws and nuts go where that I can't figure out.
 

·
Registered
Joined
·
2,118 Posts
Discussion Starter #2
never mind... found the answer. The female threaded/sharp tonged nuts go through the mounting plates on the belt, with screws connecting them from inside the belt.
 
1 - 2 of 2 Posts
Top