FN Herstal Firearms banner
1 - 15 of 15 Posts

· Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Well I finally got my USG PS90 in black today. I do like it a lot. My only complaint which you all will think is strange is that I think the cheek weld is to low. I feel like I have to put my head side ways to see the reticle which strains my eyes...
I should get my ammo and extra mags. in tomorrow :D
I would post pics but I think that would be senseless being everyone here has seen a PS90...
 

· Registered
Joined
·
21,935 Posts
It would SEEM senseless but, Its YOUR rifle!

:?


"This is my rifle, there are many like it, but this is MINE!" 8)
 

· Registered
Joined
·
545 Posts
If you eventually decide it's too low then you can always sell the USG ringsight to help finance the optic of your choice (Aimpoint ML3 in the TROS ultralow Aimpoint mount was my fav).
Tomac
 

· Registered
Joined
·
545 Posts
2nd2none said:
this is true, but I'll keep it for a while and try her out, maybe in a couple of hours. I just got my ammo and extra mags 8)
Range report! Enquiring minds want to know! :wink:
Tomac
 

· Registered
Joined
·
15 Posts
Discussion Starter · #8 ·
Well I just put 50rds of SS197 thru her, well I should say 40rds, my wife put 10rds thru her. My wife enjoyed it because of the low recoil, I of course enjoyed it a lot, and so far I am liking the USG sight. I'll have to where ear plugs next time instead of the ear muffs, the ear muffs were a bit annoying, as with most rifles. I love the capacity too! I modded the 30rd mag. before shooting, I made it so the bottom of the spring sort of clips on to the bottom plate. I did not cut it straight across I cut it to the center of the plate leaving the one vertical part intact, I did it to obviously both sides and than I cut the center part leaving about 1/16" on the bottom plate and just notched the sides a little bit where the spring made contact with it. It stays on the spring when you field strip it.
I did not shoot for accuracy yet, I just shot from about 15-18 yds standing and got my shirt all dirty from the ejecting shells :evil: But I think I can over look this. Next thing on my list is to get a shell catcher, maybe the one magparts.com has, being it holds 100rds opposed to the 50rds that the FN one holds. I am glad I have a new addition to my family. 8) :?
 

· Banned
Joined
·
4,055 Posts
Congrats on your new baby! :?
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top