FN Herstal Firearms banner
1 - 11 of 11 Posts

·
Premium Member
Joined
·
4,479 Posts
Discussion Starter · #1 ·
I noticed when I was putting the REM2 on my white ring sight that the reticles cross bar is tilted to the left. It makes me want to lean the rifle to the right to level up the sight... anyone else have one like this?
 

·
Registered
Joined
·
41 Posts
I think mine is OK. If it's off, then it's not off to a noticeable degree.

I've got a barrel laser for sight adjustment that has a level horizontal line feature on it.

If I remember, when I get home tonight I'll see if I can check it out.
 

·
Vendor
Joined
·
5,913 Posts
WOW! I have never seen that. :-? I have noticed that on some Sights the walls of the well area differ at about 20,000 of an inch. this affects the fit of the REM 2.

Now I bet everyone is going to double check to see if theirs is off.
 

·
Premium Member
Joined
·
4,479 Posts
Discussion Starter · #5 ·
I thought about that... NAH!
:-D
 

·
Registered
Joined
·
83 Posts
Every EOTech I've ever looked through is canted by one pixel too. Almost makes me not want to get one.
 

·
Registered
Joined
·
41 Posts
Got out my bore laser with the level and my stock sight "T" is slightly off in a counter-clockwise direction.

Not more than a degree or two though, and to be honest I didn't even notice it until you said something... Thanks... :?
 

·
Premium Member
Joined
·
4,479 Posts
Discussion Starter · #9 ·
Thanx for checking it. It's good to know that it isn't just me. :D

Mine is also off counter clockwise but at least 5 degrees worth. I didn't notice it until I put the REM2 on it... before then I couln't see the white ring so I didn't know it was crooked. :-D
 
1 - 11 of 11 Posts
Top