FN Herstal Firearms banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
162 Posts
Discussion Starter · #1 ·
Have a KDG stock and just installed my new Stryker SEAL lower. When posted pictures of it in the photo thread i got this comment about the stock having a an issue. Granted I havent taken a super close look at it on mine,but plan on doing so the evening and want to know what to look for and if anyone has had a similar issue. See pic below, TIA, and sorry if this has been covered I searched but couldnt find an answer. Really dont want to go out shooting with the new setup and mess anything up


"I used teflon spray on the inside of the adapter and inserted the trigger module. it showed a mark just above the indent where the tongue on the SEAL bumped up against it. I noticed also when I inserted the OEM module into the adapter the tongue flexed downward. Went back to using the original stock."

 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top