FN Herstal Firearms banner

1 - 3 of 3 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Do you do anything different than you would on any other rifle? I have a NF 3.5-15x50 in the NF unimount. Crossbolt torque is 65 IN/lb.
 

·
Registered
Joined
·
6,625 Posts
The only concern is clearing the back up iron. If you can't clear it then you may need to remove the rear. Other than that it's the same as any other.
 

·
Registered
Joined
·
30 Posts
Same concerns here, I just purchased my 17s with a Leupold VX-r Scope, not a need for backup iron since I am hunting with it, but I found the medium rings were too low so I went with the high rings, removed the rear sight and have laser bore sighted it in. Taking it out this week to get some range time zeroing it.
 
1 - 3 of 3 Posts
Top