Joined
·
1,300 Posts
Hey Guy's I am happy to report that I have started to get some of the BETA test units for my QD mounts off the mill and testing is going good. Initially I was going to add a Countersunk Washer to go with the QD mount to help mitigate point load on the hardware through the frame of the gun but after a significant amount of abuse on my own personal p90 & ps90 the frame as well as the QD and hardware are just fine.
I should have these available to you all within a few weeks. Below you will find technical specs:
Estimated MSRP is $25.00
Material: 303 Stainless steel Plated in a Melonite industry standard.
Available in both 360* & Locking
The QD mount(s) are fully ambidextrous and can mount on either side of the weapon with the existing Factory hardware or supplied Hardware for specified mounting points per PMM instructions at time of release.
I should have these available to you all within a few weeks. Below you will find technical specs:
Estimated MSRP is $25.00
Material: 303 Stainless steel Plated in a Melonite industry standard.
Available in both 360* & Locking
The QD mount(s) are fully ambidextrous and can mount on either side of the weapon with the existing Factory hardware or supplied Hardware for specified mounting points per PMM instructions at time of release.
