FN Herstal Firearms banner

1 - 1 of 1 Posts

·
Premium Member
Joined
·
1,300 Posts
Discussion Starter · #1 ·
Hey guys I have finally gotten the Logistics sorted on the PMM B.C.D. RADDLOCK compliant version!

I will be supplying Each Raddlock compliant BCD with a new left Side Mag release button shim it will be printed out of PLA with a positive infill rate of 100% all you will need to do is remove the existing LS Raddlock Stop and replace it with the supplied PMM unit and install your B.C.D.

Revision to the BCD was pretty simple i machined another Radius to clear the Bolt and Locking mechanism when the arm articulates.

Thanks to all who helped me out with this I am sending the revised B.C.D's off to the hardcoater later this week for stripping,blasting and re-plating after the rework on my end.
 
1 - 1 of 1 Posts
Top