FN Herstal Firearms banner

1 - 13 of 13 Posts

·
Registered
Joined
·
22,109 Posts
Looks good!!! :?
 

·
Vendor
Joined
·
147 Posts
Just wanted to give a thumbs up to design machine. I mounted my aimpoint T-2 to their mount made for a more natural head position compared to the stock fn rail which is worthless.
I dunno, you T-2 guys are making me want to spend money! Nice, very very nice.
 

·
Registered
Joined
·
389 Posts
I am interested in a T1 mount but I have 2 questions.
  1. I already have side rails that I want to continue to use so would you be able to ship the longer screws needed to be able to attach them with your mount?
  2. With the way your mount sits and the way the T1 sits on the mount, is there still enough room to have a Surefire x300 mounted on the side rail where the T1 dial is and still operate the dial without problems?
 

·
Registered
Joined
·
536 Posts
looks good. i have seven T2s and two H1s sitting in a box under the bed...only because i have nothing to mount them on. i think I'm going to get rid of my EOTECH HHS setup and start with this for my PS90.

just curious though...can i use the factory rails with this mount?
 

·
Vendor
Joined
·
147 Posts
Yes, they should fit with no problem. Just call me or email me when you make an order and remind me to give you some rail screws. They are just a little longer so they match the look in the front. I'll send you or anyone that needs a few some, just let me know. thank you, Duane. 401-783-0487 & [email protected]
 

·
Registered
Joined
·
225 Posts
very glad I found this thread. Just looking at Design Machine's mount and regretting spending the money on a lesser sight. Think i'm going to take back and invest in a burris fastfire3. They sit so much lower! this is looking so much better than what I have set up now. should have waited and done more research,:-(
 
1 - 13 of 13 Posts
Top