FN Herstal Firearms banner
1 - 2 of 2 Posts

· Registered
8 Posts
Discussion Starter · #1 ·
I have an old FAL that I built several years ago from a parts kit - an STG58 on an Imbel receiver. Functions great, except that the barrel is slightly under-timed. When I built the rifle I hand-carved a receiver "clamp" from wood, and used a fitted open-end wrench to torque the barrel, but was unable to get it timed exactly right. I'd like to try it again.

I'm looking for a receiver wrench and barrel vise. I only need it for one-time use, so I hate to buy one.

Does anyone have one that I could rent or borrow?

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.