Removal of FNX safety lever

3216 Views 9 Replies 7 Participants Last post by Smee78, May 13, 2015

richard.gozinya

Discussion Starter · May 7, 2015

I can see the bottom hole, but I've pried up and can not see the top release hole. Am I doing something wrong, any ideas? I'm starting to mark up the lever....

Save

1 - 2 of 10 Posts

Jarod Legsdin

· #4 · May 8, 2015

I'm running my safety levers next week for these.

Save

Reactions: 2

Jarod Legsdin

· #6 · May 8, 2015

richard.gozinya said:
Do you have a picture you can link us to? How much will they be?

Here are several images of a the proof of concept PLA printed version of what the 6061 Aluminum selector lever's units will look like they, The levers are easy to make however the main shaft that goes through the pistol is going to be made of Stainless steel and will be more costly.I an doing my best to keep the cost down but have no final pricing as of yet.

Thanks ~Jrod.

See less See more

Save

Reactions: 4

1 - 2 of 10 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month