FN Herstal Firearms banner

Removal of FNX safety lever

3231 Views 9 Replies 7 Participants Last post by  Smee78
I can see the bottom hole, but I've pried up and can not see the top release hole. Am I doing something wrong, any ideas? I'm starting to mark up the lever....
1 - 1 of 10 Posts
The FNP's had the two hole release points. The FNX uses a .028 Allen set screw to retain the safety lever. Don't pry on it without loosening that set screw. It's the same size allen wrench as the Crimson Trace lasers use to adjust their windage and elevation if you have a Crimson Trace laser on anything. Otherwise you'll probably have to order a small allen wrench set online.



Guitar Electric guitar String instrument Wood
See less See more
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.