FN Herstal Firearms banner

Removal of FNX safety lever

3216 Views 9 Replies 7 Participants Last post by  Smee78
I can see the bottom hole, but I've pried up and can not see the top release hole. Am I doing something wrong, any ideas? I'm starting to mark up the lever....
1 - 3 of 10 Posts
Do you have a picture you can link us to? How much will they be?
Thanks for the assistance everyone, the 0.28 hex wrench did the trick nicely. The new decock only FCG installed in less than 2 minutes.
1 - 3 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.