FN Herstal Firearms banner
1 - 8 of 8 Posts

·
Registered
Joined
·
94 Posts
Discussion Starter · #1 ·
I'm wanting to run a Trijicon RMR on a 45 mount on the right side of my Scar. I run a Vortex 2.5-10x32 in an ADM Delta with the levers on the right side.

Does anyone have this particular setup? My concern is whether the RMR will clear the levers and the scope turret.

Greg
 

·
Registered
Joined
·
569 Posts
How come you don't consider mounting the RMR further forward past the scope and cocking handle?
This. Do this. The RMR is designed for pistols, the front of your rifle is about the same distance as the sight would be on a pistol. I used the 1 o'clock offset from daniel defense and the LaRue mount (cause my nightforce IS HUGE and wouldn't work with the ADM mount). I put the RMR all the way up front. When you set your cheek and look through the scope, then rotate the rifle without changing cheek placement, the RMR is right where it needs to be.
 

·
Registered
Joined
·
569 Posts
Also, if you need/want the ADM RMR mount, I can sell the one that didn't work for my setup. I attempted to mount it, but never used it since it didn't fit with the NF. I have the Vortex 2.5-10x32 FFP and it WILL fit forward of that scope, but not beside it. (edit: never mind, I'm returning to the retailer)
 

·
Registered
Joined
·
94 Posts
Discussion Starter · #5 ·
I'm sorry I should have clarified a little better. I intend to move it fairly far forward, about where the charging handle stops. I was concerned the throw levers and scope turret would block my line of sight to the RMR. I have not seen one mounted in person so my concern is the exact orientation at 45 degrees and how low it sits.

Greg
 
1 - 8 of 8 Posts
Top