Sight pusher.

8101 Views 43 Replies 11 Participants Last post by Hamfisted, Apr 13, 2015

TactiTex

Discussion Starter · Mar 26, 2015

After sighting in the RMR a couple of weeks ago I found that it doesnt co witness with the irons so I broke out the depth mics and found the front site is almost .050 to the right. Just about the exact amount my co witness is off.
Can anyone recommend a sight pusher that works well with the FNX.45 Tac?

Save

1 - 4 of 44 Posts

wespac78

· #2 · Mar 26, 2015

I use the P500 sight pusher from B&J Machine. No complaints so far and it's much cheaper than the MGW Sight Pro.

Save

Reactions: 1

wespac78

· #5 · Mar 26, 2015

TactiTex said:
So no problems marring the blade on the sight or anything?

No, just use masking tape like you always should and you don't have to worry about any marks or marring.

Save

wespac78

· #7 · Mar 26, 2015

Typically, as a precaution, it is a good idea to put masking tape over any area where you may take the chance of marking or marring the finish. Just an added layer of protection 😀

Save

Reactions: 1

wespac78

· #34 · Apr 3, 2015

SeaMac said:
Yeah Donnie don't waste your money. It actually is very well made and inexpensive but unless they come up with something to secure the slide and keep if from twisting when working front sights it's a bust. For rear sights only aka Glock's it's an absolute winner no doubt. I'm going to have to call B & J Machine tomorrow and get a P500 Pro, it like no other sight tool I know of REALLY clamps the slide down and keeps it from moving. The XL is already at the USPS awaiting its journey back to California.......good riddance! :?

You'll love the P500. I have changed the sights (front and rear) on Glocks, Sig P226, P320, FNX 45, multiple 1911's, and it works like a champ. Very well built and solid unit. Good luck finding one. Guess I got lucky when I got mine a little while ago from Brownells.

Save

Reactions: 1

1 - 4 of 44 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month