FN Herstal Firearms banner

1 - 8 of 8 Posts

·
Registered
Joined
·
176 Posts
Discussion Starter #1
I appreciate some help on this. So I stripped down my SCAR to get it cerakoted. I got it back and started reassembling everything and I have 2 left over parts that I'm not sure where it goes.

#1: No idea what this one is for. It was in the same bag as all of my lower parts.

#2: This one fell out of my stock when i took it apart. I have no idea where it goes when it is reassembled.

 

Attachments

·
Premium Member
Joined
·
9,513 Posts
I think #1 is the safety detent spring.

#2 goes in the stock to cut down on rattle.
 

·
Vendor
Joined
·
1,765 Posts
#2 is definitely in the stock. It lays on top of the metal tube - you'll see an oval slot cut out. You need to remove the butt pad, and I think the bolt that holds the stock onto the metal tube, but that's going from memory.

#1 could well be the safety detent - it does use a coil spring. There should be a little pointy ended tube that goes over it.
 

·
Premium Member
Joined
·
9,513 Posts
THANKS! #2 makes a whole lot of sense now.

As for #1, its not the safety detent spring. I already have the safety reassembled with the detent and spring.
Are the mag catch and bolt catch installed? It could be the spring for either of those. But honestly, I'm kinda guessing.
 
1 - 8 of 8 Posts
Top