FN Herstal Firearms banner

1 - 5 of 5 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
Having read through some of the muzzle device threads I'd thought I would post up my experience on mounting a Surfire SOCOM762 to my 17S. In a nutshell, easy. used an AR15 armorers tool to grab the existing PWS break and a crescent wrench to grab the locking nut. Little bit of effort and it dismounted without issue. The SF break comes with a space that has an inner chamfered edge on one side. You place the spacer on first with that chamfered side point toward the muzzle. This way you get a decent abutment to the minuscule barrel shoulder. Then figure out your shims to properly time the brake, clean the threads, apply rockset, reattach and torque as required. All in all pretty easy. As has been mentioned before you can vise the barrel with a simple jig of wood vise inserts that have a V notch <> or semicircles () cut to bite the barrel. I then use a Super Black pen to kill the shine of the spacers.
HTH.
 

Attachments

·
Registered
Joined
·
23 Posts
You will probably see some forum remarks about the 17S barrel shoulder being less than nominal for a surefire 7.62 suppressor mounted on the SOCOM 762 muzzle brake. That is, after several firing, the suppressor is not aligned with the barrel leading to a possible baffle strike. See SCAR 17 Muzzle Device Compatibility List.
However, you can check the suppressor/muzzle brake/barrel alignment with a GEISSELE AUTOMATICS LLC 7.62MM SUPPRESSOR ALIGNMENT ROD. Rod is available at Brownells and MidwayUSA.
I mounted the Surefire SFMB-762;5/8-24 Muzzle Brake with the Surefire SOCOM 762-RC QD suppressor on my 17S and have had no issues. Before I go to the range, I do a Geissele rod alignment check.
 

·
Registered
Joined
·
27 Posts
Discussion Starter · #4 ·
D2randall, thanks for the info. Indeed $75 would see like money well spent to prevent suppressor damage. Current plan is to run the 762RC on both the SCAR and on a 5.56 build.
 
1 - 5 of 5 Posts
Top