FN Herstal Firearms banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
I have a new Hi Power Mark III and have put about 400 rounds through it. When cleaning and reassembling it seems that the ejector is hitting the slide instead of going in the slot provided. Has anyone else had this problem? If so how did you solve it.
 

·
Registered
Joined
·
2,118 Posts
Did you completely disassemble/detail strip it? Or just field strip it? If the former, did you make sure get the sear pin all the way back through the ejector? If the latter, have a close look at the sear pin and make sure it hasn't slipped to the right, allowing the ejector to pivot up.


 

·
Registered
Joined
·
2 Posts
The sear pin will also bend fairly easily. If you managed to disengage the sear with the slide off and the hammer flew forward unrestrained, it may have bent slightly. Cheap to replace if you find one. Good luck.
 
1 - 4 of 4 Posts
Top