FN Herstal Firearms banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
3,114 Posts
Discussion Starter · #1 ·
I've had this Monolith Arms Railed Forearm sitting in my safe for years and have decided I don't have the time to take on the project so it's up for grabs. As I was told, this forearm was sent back to Monolith Arms and they machined off the molded bottom rail and installed an aluminum bottom rail instead; apparently the molded rail was out of spec or broken, if I remember correctly(it's been awhile?). Now for the bad news: Both front locking tabs were broken and repaired with what looks like epoxy resin(not my repair). The forearm installs fine but I would be hesitant to field the rifle in this condition, which I never intended on doing. My intention was to use this as a model to recreate a similar/better forearm and use this forearm for dimensions, etc. That being said, hopefully one of the FNF members with access to 3D printing technology can do all of us FS2000 owners a real service and design a better mousetrap, using this original piece as a baseline. Item is located in WA, 98801. Asking $200 + actual shipping to the lower 48; no trades. Paypal gift or add 4%, or USPS Money Order works as well. PM me with any questions(I'm sure there will be many) so jhs27275 doesn't have to scold and clean up the thread please... he's busy enough as is. Apologize for the novella but this item required some explanation/details.



















 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top