FN Herstal Firearms banner

1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
One more from a newbie. I have Yankee Hill BUIS that orignally was used on an AR which I want to use to improve the factory Iron sights. They seem awfully high compared to the factory sights. Is there a special/different lower version of BUIS I should be using?

Also does anyone remove the factory iron sights when doing this and does doing so offer any advantages like more room or clearance etc? Thanks.
 

·
Registered
Joined
·
124 Posts
I took off the factory front sight and have my YHM front and ARMS-40 rear sight on with my EO. Had to take apart the upper slightly to get one of the sights to slip over the rail because of the sling holder was in the way.
 
1 - 2 of 2 Posts
Top