What is included in the Accurizing Service

EA Ammunition tested in gun for function

• Removal of magazine safety
• Smoothing of the hammer to sear contact. Greatly improves trigger action and creates a crisp release
• Reducing trigger pull by 50%
• Increase hammer spring pre-load 20-30% for crisper disconnect
• Chamber lapping. Aids in extraction and protection of coating on brass
• Polish and Tune extractor
• Polishing and Fitting (too much to list) and a detailed cleaning including correct lubrication
• Each gun is tested to deliver a 4-pound trigger pull before leaving the shop.
• FYI Since we have had a few requests. YES we can leave the magazine disconnect safety in place. YES leaving it in place will affect the trigger pull and the trigger pull will not be as good as without it. How much is subjective and varies from gun to gun.

Not worth $350 in my opinion. The trigger is already smooth as is and much improvement prob wont be noticeable. $350 can buy a lot of things!

 

Unless that is a 4 lb. DA pull it's not worth it. All my target stuff is 2.5-3 lbs. in SA.
I can hit twice as good witha 3 lb. trigger as I can a 4.5 lb trigger.
But $350 is too much for a port and polish and a trigger job.

 

AFAIK, the FsN is SAO - single action only.

 

Please let me know what your thoughts or concerns are for this process.

It voids the warranty.

 

And EA's threaded barrel comes with chamber lapping...for the same price as accurizing. Just saying...I'd rather get that, and not give up my gun for weeks...although I believe they use EFK (correct me if I'm wrong) and people are divided on EFK vs Jarvis.

 

people are divided on EFK vs Jarvis.

Jarvis is the best option there is. :?

 

Ah ok the FsN is SA only. My bad, thanks for the correction.

 

The Jarvis barrel is well worth the wait.

 

Thank you for the advice. Looking into the Jarvis barrel ASAP.

 

Jarvis barrel was well worth it. Just got back from some suppressed shooting. Absolutely flawless, couldn't be happier

 

They no longer remove the mag safety as it aids magazine removal when dropping mags (downward pressure). They modify the trigger bar akin to the old FSN models without the MS. This of course voids warranty. All of the other work is standard gun smith trigger work. Not sure if FN would void your warranty for polishing a couple contact points, and polishing the chamber.. With that being said, my FSN had a really heavy trigger pull. 6-6.75lbs~ <br/>

 

I noticed a seat-of-the-pants increase in trigger pull when I went to the MK2.

 

Can we fix the 1 video per message thing?

Even after reinstalling the mag safety and 300-400 rounds it's now about 3lbs even. I'd say it's worth it for those who have heavy stock triggers..

 

Can we fix the 1 video per message thing? ....

Not at this time. I asked about this some time ago a 1 video per post limit was placed on the site.

I will address this concern again.